PP3EZ
The PP3EZ speeds you through the diagnosing of 12 to 24 volt automotive electrical systems.



PP3EZ
The PP3EZ speeds you through the diagnosing of 12 to 24 volt automotive electrical systems.
The Power Probe 3S’s features are included in the PP3EZ, with two extra modes: EZ Learning and EZ Diagnostics. A technician can quickly check a circuit’s voltage and polarity by connecting the PP3EZ clips to the vehicle’s battery, without needing a voltmeter or switching clips. The power switch allos for testing electrical components by conducting a positive or negative battery current to the tip, eliminating the need for jumper leads.
Ultimate multifunction scan tool kit for any workshop
Overview
Specs
Brochure
Videos
Overview
- Apply power or ground
- Test motors, blowers, lights, wires, fuses for operation
- Test for good/bad grounds
- Test continuity
- 5V reference with 5V adapter
Specs
Category | Specifications |
---|---|
Storage temperature / humidity | -20 to 700C, 70% RH max |
Operating temperature / humidity | -10 to 500C, 70% RH max |
Pollution degree | 2 |
DC Voltage | 0 to +70 Volts +1 digit |
P-P Voltage | 0 to +70 Volts |
Frequency Response | 10Hz to 10kHz (for tone pass through) |
P-P Display | 15Hz Square Wave / 35Hz Sine Wave |
DC Voltmeter Mode – Continuity to ground |
|
Over Volt Warning | If the probe tip connects to the voltage greater than +70 Volts the display will show an “Over Volt” warning. Remove the probe tip immediately to prevent internal damage to the tool. |
Over Load Warning | If the probe is connected to a battery with voltage greater than 34VDC the display will show an “Over Load” warning. |
Circuit Breaker | 8 amp thermal response – Manual reset Typical Response |
Brochure
Videos